CHINESE JOURNAL OF AERONAUTICS
- A theoretical method for solving shock relations coupled with chemical equilibrium and its applications
- A compressing and saving method for structured grid data based on block construction
- Stability characteristics and airworthiness requirements of blended wing body aircraft with podded engines
- Experimental investigation of a gliding discharge plasma jet igniter
- Evolution of turbulent boundary layer over a three-dimensional bump
- GroupNet: Learning to group corner for object detection in remote sensing imagery
- Optimization of cooling structures in gas turbines:A review
- Modified attitude factor graph fusion method for unmanned helicopter under atmospheric disturbance
- Modified rolling guidance law for single moving mass controlled reentry vehicle against maneuvering target with impact angle constraints
- An air-rail inter-modal strategy for aircraft recovery
- Sub-optimal fixed-finite-horizon spacecraft configuration control on SE(3)
- Study of aerodynamic and inertial forces of a dovelike flapping-wing MAV by combining experimental and numerical methods
- Numerical investigation on leakage and rotordynamic performance of the honeycomb seal with swirl-reverse rings
- Calibration method of quartz accelerometer on dynamic centrifuge
- A numerical study of segmented cooling-stream injection in supersonic film cooling
- Characteristics of reattached boundary layer in shock wave and turbulent boundary layer interaction
- Structurally coupled characteristics of rotor blade using new rigid-flexible dynamic model based on geometrically exact formulation
- Conceptual design and preliminary experiment of icing risk management and protection system
- Shape preserving topology optimization for structural radar cross section control
- Autonomous mission reconstruction during the ascending flight of launch vehicles under typical propulsion system failures
- Dynamic thermal coupling modeling and analysis of wet electro-hydrostatic actuator
- An inverse strategy to determine constitutive parameters of tubular materials for hydroforming processes
- Distributed state estimation for linear timeinvariant dynamical systems: A review of theories and algorithms
- Direct thrust control for multivariable turbofan engine based on affine linear parameter-varying approach
- Error modeling and compensating of a novel 6-DOF aeroengine rotor docking equipment
- Comparison of surface integrity for dry and wet drilling of 49Fe-49Co-2V alloy
- Influence of alumina abrasive tool wear on ground surface characteristics and corrosion properties of K444 nickel-based superalloy
- Pipelines vibration analysis and control based on clamps’ locations optimization of multi-pump system
- An integrated preforming-performance model for high-fidelity performance analysis of cured woven composite part with non-orthogonal yarn angles
- On a plastic instability criterion for ultra-large radial-axial ring rolling process with four guide rolls
- Role of hydrogen in the dissociation of CH4 on different graphene by DFT study
- Analysis of crack initiation location and its influencing factors of fretting fatigue in aluminum alloy components