CHINESE JOURNAL OF AERONAUTICS
- Enhanced baseline determination for formation flying LEOs by relative corrections of phase center and code residual variations
- Adjoint boundary sensitivity method to assess the effect of nonuniform boundary conditions
- Nonlinear uncertainty quantification of the impact of geometric variability on compressor performance using an adjoint method
- Review on anti-loosening methods for threaded fasteners
- Reliability evaluation of PMS considering coupling effect of functional and physical dependency
- Mission segment division of the whole aeroengine loading spectrum based on flight actions
- Accelerated Landweber iteration based control allocation for fault tolerant control of reusable launch vehicle
- Guide for Authors
- Transit time difference and equal or non-equal transit time theory for airfoils with lift
- High precision and efficiency robotic milling of complex parts:Challenges,approaches and trends
- A boundary surrogate model for micro/nano grooved surface structure applied in turbulence flow control over airfoil
- Trajectory and attitude deviations for internal store separation due to unsteady and quasi-steady test method
- Passage shock wave/boundary layer interaction control for transonic compressors using bumps
- Radiative properties of alumina/aluminum particles and influence on radiative heat transfer in solid rocket motor
- Effect of system response on partial surge initiated instability in a transonic axial flow compressor
- Simultaneous optimization of structure together with attached tuned mass dampers considering dynamic performance
- Theoretical model and testing method for ball indentation based on the proportional superposition of energy in pure elasticity and pure plasticity
- Study on the resolution of multi-aircraft flight conflicts based on an IDQN
- Robust spline-line energy management guidance algorithm with multiple constraints and uncertainties for solid rocket ascending
- Flight control of a large-scale flapping-wing flying robotic bird:System development and flight experiment
- A novel approach to the attitude stabilization structure for ducted-fan operative aerial robots:Finding improvements for modeling error and strong external transient disturbance
- Distributed state estimation for heterogeneous mobile sensor networks with stochastic observation loss
- Experimental and numerical study of deposition mechanisms for cold spray additive manufacturing process
- Formability enhancement in hot spinning of titanium alloy thin-walled tube via prediction and control of ductile fracture
- Vibration coupling effects and machining behavior of ultrasonic vibration plate device for creep-feed grinding of Inconel 718 nickel-based superalloy
- Positioning error compensation of an industrial robot using neural networks and experimental study
- Surface morphology characterization of unidirectional carbon fibre reinforced plastic machined by peripheral milling
- Electrochemical cutting of mortise-tenon joint structure by rotary tube electrode with helically distributed jet-flow holes
- Pressure-induced instability and its coupled aeroelasticity of inflated pillow
- Multi-channel discharge characteristics cutting by ultra-fine wire-EDM
- Effect of cooling strategies on performance and mechanism of helical milling of CFRP/Ti-6Al-4 V stacks
- Effect of assisted transverse magnetic field on distortion behavior of thin-walled components in WEDM process