REVIEW ARTICLE

• Plastic wrinkling prediction in thin-walled part forming process:A review
• Progress of continuously rotating detonation engines
• Microstructure control techniques in primary hot working of titanium alloy bars:A review

Fluid Mechanics and Flight Mechanics

• A hybrid original approach for prediction of the aerodynamic coefficients of an ATR-42 scaled wing model
• Dynamic modeling and analysis of vortex filament motion using a novel curve- fitting method
• Boundary-layer transition prediction using a simpli fied correlation-based model
• Aeroelastic scaling laws for gust load alleviation control system
• An investigation of tip vortices unsteady interaction for Fokker 29 propeller with swirl recovery vane
• Characteristic analysis of lock-in for an elastically suspended airfoil in transonic bu ff et flow

Liu Yi，Xie Changchuan，Yang Chao，Cheng Jialin

• Gust response analysis and wind tunnel test for a high-aspect ratio wing

Zhang Shaowen，David G. MacManus，Luo Jianqiao

• Parametric study of turbine NGV blade lean and vortex design

Solid Mechanics and Vehicle Conceptual Design

• Nonlinear flutter wind tunnel test and numerical analysis of folding fins with freeplay nonlinearities
• Non-uniform hybrid strategy for architecting and modeling flight vehicle focused system-of-systems operations
• Nonlinear thermomechanical deformation behaviour of P-FGM shallow spherical shell panel

Electronics and Control

• Trajectory optimization of multiple quad-rotor UAVs in collaborative assembling task
• Three-dimensional guidance law based on adaptive integral sliding mode control
• Indirect Radau pseudospectral method for the receding horizon control problem
• A novel biased proportional navigation guidance law for close approach phase
• Singularity problem of control moment gyro cluster with vibration isolators
• A new method of single celestial-body sun positioning based on theory of mechanisms

Material Engineering and Mechanical Manufacturing

• Out of phase thermal mechanical fatigue investigation of a directionally solidi fied superalloy DZ125
• Experimental research on electrochemical machining of titanium alloy Ti60 for a blisk
• Formation of interlayer gap and control of interlayer burr in dry drilling of stacked aluminum alloy plates
• Analyses toward factors in fluencing sealing clearance of a metal rubber seal and derivation of a calculation formula

• Ultrasound assisted solidi fication process of ternary Cu–Sn–Sb alloy