2023年5期
Journal of Wuhan University of Technology(Materials Science Edition)
Advanced materials
- Core-shell-embedded Mesoporous Silica Capsules for Atmospheric Water Harvesting
- Preparation of B2O3-ZnO-SiO2 Glass and Sintering Densification of Copper Terminal Electrode Applied in Multilayer Ceramic Capacitors
- Structural Characterization of Carbon-implanted GaSb
- Development of Eggshell Waste Incorporated with a Porous Host as a Humidity Adsorption Material
- Low Temperature Heat Capacity of Zn Substituted Cobalt Ferrite Nanosphere: The Relation between Magnetic Properties and Microstructure
- The Enhanced Electrons and Holes Separation for Bi2MoO6/TiO2 Z-scheme Heterojunction by Ag Loading
- Magnetically Separable Straw@Fe3O4/Cu2O Composites for Photocatalytic Degradation of Methyl Orange under Visible Light Irradiation
- Theoretical Predition of Two-dimensional SiGeP2 by the Global Optimization Method
- Mixed-Alkali Effect on Thermal Property and Elastic Behavior in Borosilicate Glasses
- Improvement of AlN Thermal Conductivity Based on Reductive Compound Additives
Cementitious materials
- Dynamic Impact Compressive Behavior Investigation of Sisal Fiber-reinforced Coral Seawater Concrete
- Research and Prediction on the Properties of Concrete at Cryogenic Temperature Based on Gray Theory
- Ferro-vanadium Slag in Improving Inner Chloride Solidification Rate of Cement Materials
- Influence of Na2SiO3/NaOH Ratio on Calcined Magnesium Silicate Based Geopolymer—Experimental and Predictive Study
- Compressive Strength ofBasic Magnesium Sulfate Cement Coral Aggregate Concrete (MCAC) on Non-Destructive Testing
- The Research for Surface Properties of Steel Slag Powder and High-Temperature Rheological Properties of Asphalt Mortar
- A Novel Process of CO2 Reduction and CO2 Sequestration Through an Innovative Accelerated Carbonation Technique
- The Influence of Mesoscopic Characteristics of Mineral Powders Fillers on the Rutting Factor(G＊/sinδ) of Asphalt Mortar
- Preparation and Microwave Absorbing Properties of Double-layer Fine Iron Tailings Cementitious Materials
- Simulation of Cement Hydration and Porous Structures by the Hydration-Pixel Probability Model
Metallic materials
- Tribological Properties of Ti-DLC Coatings on Piston-pin Surfaces
- Numerical Simulation Investigation on Split Sleeve Cold Expansion of Ti-Al Stacked Structure
- Preparation of Zr-Cu Coatings on Copper Substrate Using a Molten Salt Method
- Microstructure and Mechanical Properties of Al-11.3Zn-3.2Mg-1.3Cu-0.2Zr-0.1Sr-xTi Extruded Aluminum Alloy with Different Aging Process
- Effect of Strain Ratio on Fatigue Model of Ultra-fine Grained Pure Titanium
- Effect of Pouring Temperature by a Novel Micro Fused-Casting on Microstructure and Properties of ZL101 Semisolid Slurry