Review

• Measuring reliability under epistemic uncertainty:Review on non-probabilistic reliability metrics

Fluid Mechanics and Flight Mechanics

• Optimum blade loading for a powered rotor in descent
• Experimental study of ice accretion effects on aerodynamic performance of an NACA 23012 airfoil
• Parachute dynamics and perturbation analysis of precision airdrop system
• Simulative technology for auxiliary fuel tank separation in a wind tunnel
• Large-eddy simulation of shock-wave/turbulent boundary layer interaction with and without SparkJet control
• Ground experimental investigations into an ejected spray cooling system for space closed-loop application
• Numerical study of corner separation in a linear compressor cascade using various turbulence models
• Effect of blade tip winglet on the performance of a highly loaded transonic compressor rotor

Solid Mechanics and Vehicle Conceptual Design

• Remaining useful life estimation for deteriorating systems with time-varying operational conditions and condition-specific failure zones
• Nonlinear dynamic modeling of a helicopter planetary gear train for carrier plate crack fault diagnosis

Electronics and Control

• Decentralized adaptive sliding mode control of a space robot actuated by control moment gyroscopes
• A new non-specificity measure in evidence theory based on belief intervals
• Near minimum-time feedback attitude control with multiple saturation constraints for agile satellites
• Yaw controller design of stratospheric airship based on phase plane method
• A fast pulse phase estimation method for X-ray pulsar signals based on epoch folding
• Hierarchical space–time block codes signals classification using higher order cumulants
• Wavelength dimensioning for wavelength-routed WDM satellite network
• High-precision RCS measurement of aircraft's weak scattering source
• Simultaneous state and actuator fault estimation for satellite attitude control systems

Material Engineering and Mechanical Manufacturing

• Remaining useful life prediction based on the Wiener process for an aviation axial piston pump
• Motion synchronization in a dual redundant HA/EHA system by using a hybrid integrated intelligent control design
• Modeling of reliability and performance assessment of a dissimilar redundancy actuation system with failure monitoring
• Performance optimization of grooved slippers for aero hydraulic pumps
• Prediction of cutting forces in ball-end milling of 2.5D C/C composites
• Optimization on cooperative feed strategy for radial–axial ring rolling process of Inco718 alloy by RSM and FEM

• Guide for Authors